Skip to main content

View Diary: Abbreviated Pundit Round-up (74 comments)

Comment Preferences

  •  Torlon is of a particular class of plastics (0+ / 0-)

    That are both extremely expensive and difficult to work with. Using them in a 3D printer would be problematic, as just the humidity in the air would be enough to make the parts too brittle to stand up.

    Again, a single shot weapon is very, very simple to make. I'll challenge any 3D printer anywhere that I can make single shot guns all day cheaper, faster, and more reliably.

    These things are not replicators.

    •  You don't see that progess will be made ? (0+ / 0-)

      You are thinking the development has run into a dead end ?

      I didn't say people could use Torlon in a printer today or that Torlon was the solution . I brought up the plastic motor to show that some things many would think impossible , are in fact more than possible .

       

      Drop the name-calling MB 2/4/11 + Please try to use ratings properly! Kos 9/9/11 + Trusted Users have a responsibility to police the general tenor... Hunter 5/26/06

      by indycam on Sun May 12, 2013 at 11:05:29 AM PDT

      [ Parent ]

Subscribe or Donate to support Daily Kos.

Click here for the mobile view of the site